Aironet 2800 Firmware

An issue was discovered in the ALFA Windows 10 driver 6.1316.1209 for AWUS036H. The WEP, WPA, WPA2, and WPA3 implementations accept plaintext frames in a protected Wi-Fi network. An adversary can abuse this to inject arbitrary data frames independent of the network configuration.Show less

An issue was discovered in the kernel in NetBSD 7.1. An Access Point (AP) forwards EAPOL frames to other clients even though the sender has not yet successfully authenticated to the AP. This might be abused in projected Wi-Fi networks to launch denial-of-service attacks against connected clients and makes it easier to exploit other vulnerabilities in connected clients.Show less

The 802.11 standard that underpins Wi-Fi Protected Access (WPA, WPA2, and WPA3) and Wired Equivalent Privacy (WEP) doesn't require that all fragments of a frame are encrypted under the same key. An adversary can abuse this to decrypt selected fragments when another device sends fragmented frames and the WEP, CCMP, or GCMP encryption key is periodically renewed.Show less

A vulnerability in the bridge protocol data unit (BPDU) forwarding functionality of Cisco Aironet Access Points (APs) could allow an unauthenticated, adjacent attacker to cause an AP port to go into an error disabled state. The vulnerability occurs because BPDUs received from specific wireless clients are forwarded incorrectly. An attacker could exploit this vulnerability on the wireless network by sending a steady stream of crafted BPDU frames. A successful exploit could allow the attacker to cause a limited denial of service (DoS) attack because an AP port could go offline.Show less

A vulnerability in the Control and Provisioning of Wireless Access Points (CAPWAP) protocol implementation of Cisco Aironet and Catalyst 9100 Access Points (APs) could allow an unauthenticated, adjacent attacker to cause an affected device to restart unexpectedly, resulting in a denial of service (DoS) condition. The vulnerability is due to improper resource management during CAPWAP message processing. An attacker could exploit this vulnerability by sending a high volume of legitimate wireless management frames within a short time to an affected device. A successful exploit could allow the attacker to cause a device to restart unexpectedly, resulting in a DoS condition for clients associated with the AP.Show less

A vulnerability in Cisco Aironet Access Points (APs) Software could allow an unauthenticated, remote attacker to gain unauthorized access to a targeted device with elevated privileges. The vulnerability is due to insufficient access control for certain URLs on an affected device. An attacker could exploit this vulnerability by requesting specific URLs from an affected AP. An exploit could allow the attacker to gain access to the device with elevated privileges. While the attacker would not be granted access to all possible configuration options, it could allow the attacker to view sensitive information and replace some options with values of their choosing, including wireless network configuration. It would also allow the attacker to disable the AP, creating a denial of service (DoS) condition for clients associated with the AP.Show less

A vulnerability in the implementation of Protected Extensible Authentication Protocol (PEAP) functionality for standalone configurations of Cisco Aironet 1800, 2800, and 3800 Series Access Points could allow an unauthenticated, adjacent attacker to bypass authentication and connect to an affected device. The vulnerability exists because the affected device uses an incorrect default configuration setting of fail open when running in standalone mode. An attacker could exploit this vulnerability by attempting to connect to an affected device. A successful exploit could allow the attacker to bypass authentication and connect to the affected device. This vulnerability affects Cisco Aironet 1800, 2800, and 3800 Series Access Points that are running a vulnerable software release and use WLAN configuration settings that include FlexConnect local switching and central authentication with MAC filtering. Cisco Bug IDs: CSCvd46314.Show less

A vulnerability in Extensible Authentication Protocol (EAP) ingress frame processing for the Cisco Aironet 1560, 2800, and 3800 Series Access Points could allow an unauthenticated, Layer 2 radio frequency (RF) adjacent attacker to cause the Access Point (AP) to reload, resulting in a denial of service (DoS) condition. The vulnerability is due to insufficient validation of the EAP frame. An attacker could exploit this vulnerability by sending a malformed EAP frame to the targeted device. A successful exploit could allow the attacker to cause the AP to reload, resulting in a DoS condition while the AP is reloading. It may be necessary to manually power cycle the device in order for it to recover. This vulnerability affects the following Cisco products running either the Lightweight AP Software or Mobility Express image: Aironet 1560 Series Access Points, Aironet 2800 Series Access Points, Aironet 3800 Series Access Points. Note: The Cisco Aironet 1560 Series Access Point device is supported as of release 8.3.112.0. Cisco Bug IDs: CSCve18935.Show less

A vulnerability in 802.11 association request frame processing for the Cisco Aironet 1560, 2800, and 3800 Series Access Points could allow an unauthenticated, Layer 2 radio frequency (RF) adjacent attacker to cause the Access Point (AP) to reload, resulting in a denial of service (DoS) condition. The vulnerability is due to insufficient frame validation of the 802.11 association request. An attacker could exploit this vulnerability by sending a malformed 802.11 association request to the targeted device. An exploit could allow the attacker to cause the AP to reload, resulting in a DoS condition while the AP is reloading. This vulnerability affects the following Cisco products running either the Lightweight AP Software or Mobility Express image: Aironet 1560 Series Access Points, Aironet 2800 Series Access Points, Aironet 3800 Series Access Points. Note: The Cisco Aironet 1560 Series Access Point device is supported as of release 8.3.112.0. Cisco Bug IDs: CSCve12189.Show less