Fabric Operating System

An Improper Check for Unusual or Exceptional Conditions vulnerability in Brocade Fabric OS before 9.2.2.a could allow an authenticated, network-based attacker to cause a Denial-of-Service (DoS). The vulnerability is encountered when supportsave is invoked remotely, using ssh command or SANnav inline ssh, and the corresponding ssh session is terminated with Control C (^c ) before supportsave completion. This issue affects Brocade Fabric OS 9.0.0 through 9.2.2Show less

A command injection vulnerability in Brocade Fabric OS before 9.2.0c, and 9.2.1 through 9.2.1a on IP extension platforms could allow a local authenticated attacker to perform a privileged escalation via crafted use of the portcfg command. This specific exploitation is only possible on IP Extension platforms: Brocade 7810, Brocade 7840, Brocade 7850 and on Brocade X6 or X7 directors with an SX-6 Extension blade installed. The attacker must be logged into the switch via SSH or serial console to conduct the attack.Show less

A segmentation fault can occur in Brocade Fabric OS after Brocade Fabric OS v9.0 and before Brocade Fabric OS v9.2.0a through the passwdcfg command. This could allow an authenticated privileged user local user to crash a Brocade Fabric OS swith using the cli “passwdcfg --set -expire -minDiff“.Show less

A vulnerability in Brocade Fabric OS software v9.1.1, v9.0.1e, v8.2.3c, v7.4.2j, and earlier versions could allow a remote unauthenticated attacker to execute on a Brocade Fabric OS switch commands capable of modifying zoning, disabling the switch, disabling ports, and modifying the switch IP address.Show less

An insufficiently protected credentials vulnerability exists in curl 4.9 to and include curl 7.82.0 are affected that could allow an attacker to extract credentials when follows HTTP(S) redirects is used with authentication could leak credentials to other services that exist on different protocols or port numbers.Show less

An improper authentication vulnerability exists in curl 7.33.0 to and including 7.82.0 which might allow reuse OAUTH2-authenticated connections without properly making sure that the connection was authenticated with the same credentials as set for this transfer. This affects SASL-enabled protocols: SMPTP(S), IMAP(S), POP3(S) and LDAP(S) (openldap only).Show less