Memory Allocation with Excessive Size Value

A vulnerability in the Session Initiation Protocol (SIP) of Cisco Expressway Series and Cisco TelePresence Video Communication Server (VCS) could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to incorrect handling of incoming SIP traffic. An attacker could exploit this vulnerability by sending a series of SIP packets to an affected device. A successful exploit could allow the attacker to exhaust memory on an affected device, causing it to crash and leading to a DoS condition.Show less

Tendermint before versions 0.33.3, 0.32.10, and 0.31.12 has a denial-of-service vulnerability. Tendermint does not limit the number of P2P connection requests. For each p2p connection, it allocates XXX bytes. Even though this memory is garbage collected once the connection is terminated (due to duplicate IP or reaching a maximum number of inbound peers), temporary memory spikes can lead to OOM (Out-Of-Memory) exceptions. Additionally, Tendermint does not reclaim activeID of a peer after it's removed in Mempool reactor. This does not happen all the time. It only happens when a connection fails (for any reason) before the Peer is created and added to all reactors. RemovePeer is therefore called before AddPeer, which leads to always growing memory (activeIDs map). The activeIDs map has a maximum size of 65535 and the node will panic if this map reaches the maximum. An attacker can create a lot of connection attempts (exploiting above denial of service), which ultimately will lead to the node panicking. These issues are patched in Tendermint 0.33.3 and 0.32.10.Show less

The Kubelet component in versions 1.15.0-1.15.9, 1.16.0-1.16.6, and 1.17.0-1.17.2 has been found to be vulnerable to a denial of service attack via the kubelet API, including the unauthenticated HTTP read-only API typically served on port 10255, and the authenticated HTTPS API typically served on port 10250.Show less

In version from 3.0.0 to 3.5.3 of Eclipse Vert.x, the WebSocket HTTP upgrade implementation buffers the full http request before doing the handshake, holding the entire request body in memory. There should be a reasonnable limit (8192 bytes) above which the WebSocket gets an HTTP response with the 413 status code and the connection gets closed.Show less

In Eclipse Mosquitto 1.4.14, if a Mosquitto instance is set running with a configuration file, then sending a HUP signal to server triggers the configuration to be reloaded from disk. If there are lots of clients connected so that there are no more file descriptors/sockets available (default limit typically 1024 file descriptors on Linux), then opening the configuration file will fail.Show less

In Eclipse Mosquitto 1.4.14, a user can shutdown the Mosquitto server simply by filling the RAM memory with a lot of connections with large payload. This can be done without authentications if occur in connection phase of MQTT protocol.Show less