Reachable Assertion

The NXP LPUART serial driver (drivers/serial/uart_mcux_lpuart.c), when CONFIG_UART_USE_RUNTIME_CONFIGURE is enabled, called LPUART_Deinit() at the start of mcux_lpuart_configure(), which disables the LPUART peripheral clocks. The requested configuration is validated only afterwards (in mcux_lpuart_configure_basic), and unsupported parity/data-bit/stop-bit/flow-control values return -ENOTSUP before the clock is re-enabled. As a result, a uart_configure() request with an unsupported configuration left the LPUART in a clock-disabled state; any subsequent access to LPUART registers (poll_out/poll_in, interrupt handling, or a later reconfigure) faults on the gated peripheral and escalates to a hard fault, crashing the system. uart_configure() is a Zephyr syscall whose verifier (z_vrfy_uart_configure) only checks that cfg is readable user memory and forwards the caller-supplied configuration unchanged, so an unprivileged userspace thread with access to an LPUART device can deterministically trigger the fault, a persistent system-wide denial of service. Introduced in v2.5.0 and present in all subsequent releases until this fix, which removes the LPUART_Deinit() call and instead only disables the transmitter/receiver, leaving the clock running.Show less

Reachable Assertion (CWE-617) in Elasticsearch can lead to denial of service via Input Data Manipulation (CAPEC-153). A specially crafted search request containing a null value in a specific query clause causes an internal assertion to be raised during query parsing. Because Elasticsearch treats assertion failures as fatal errors, this terminates the affected node process. A low-privileged authenticated user with read access to at least one index can exploit this condition with a single request to cause a node to terminate, disrupting search availability. In a single-node deployment this fully stops Elasticsearch; in a multi-node cluster it reduces cluster capacity for each affected node.Show less

Quicly is an IETF QUIC protocol implementation intended primarily for use within the H2O HTTP server. Prior to commit 937d0e9, an assertion failure is raised when the total number of valid handshake messages received over a CRYPTO stream of a single packet number space exceeds 32KB, causing a Denial of Service. This issue has been fixed by commit 937d0e9.Show less

A reachable assertion vulnerability exists in the Matter SDK (connectedhomeip) before 1.4.0, in the interaction model command processing logic. When an InvokeCommandRequest is sent to a nonexistent endpoint and cluster (e.g., 0x34), the code incorrectly treats the endpoint as valid due to missing checks in CodegenDataModelProvider::Invoke. This causes a VerifyOrDie failure in ProcessCommandDataIB and results in a crash (SIGABRT). The issue has been acknowledged and fixed in a later revision (PR #37207).Show less

A reachable assertion vulnerability exists in the Matter SDK (connectedhomeip) before 1.4.2, specifically within the Level Control cluster's periodic server tick logic. When a MoveToLevel command is sent and immediately followed by a write of OperationMode=2 (in the Pump Configuration and Control cluster), the server tick function violates the assertion `currentLevel < maxLevel`, resulting in a crash. This can be exploited remotely without authentication to cause denial of service. Affected versions include 1.3 and 1.4 (commit ab3d5ae).Show less

A reachable assertion vulnerability exists in the Matter SDK (connectedhomeip) 1.3 thru 1.4, specifically within the Level Control cluster's server tick logic (`emberAfLevelControlClusterServerTickCallback`). When a MoveToLevel command is executed and followed by a conflicting write to the OperationMode attribute (in the Pump Configuration and Control cluster), an invariant check (`minLevel < currentLevel`) fails and causes the device to abort. This leads to a denial of service condition. The issue is confirmed in SDK versions 1.3 and 1.4 (commit ab3d5ae), and is triggered remotely without authentication.Show less

NVIDIA TensorRT-LLM contains a vulnerability in the OpenAI-compatible inference API where an attacker could trigger a reachable assertion in the sampler thread. A successful exploit of this vulnerability might lead to denial of service.Show less

vLLM is a library for LLM inference and serving. From 0.12.0 to before 0.24.0, sending a pure prompt embeds payload in a /v1/completions request with a model using M-RoPE causes EngineCore to fail an assertion and fatally crash, shutting down the entire server application. Any remote user who is authorized to make a /v1/completions request can make such a request and induce a crash. This issue is fixed in version 0.24.0.Show less

OpenVPN version 2.6.0 through 2.6.20 and 2.7_alpha1 through 2.7.4 allows remote attackers to cause a denial of service via a malformed authentication token that triggers a reachable assertion when external-auth is enabledShow less

Libreswan, via the function RSA_authenticate_hash_signature_pkcs1_1_5_rsa(), did not correctly verify the DER encoding of the ASN.1 digest when the IKEv2 AUTH payload was encoded using RSASSA-PKCS1-v1_5 (RFC 8017). A remote attacker can use a variation on the Bleichenbacher attack to forge the AUTH payload when small public exponents are used (e.g., e=3), leading to impersonation. Additionally, a remote attacker, by encoding a shorter than expected hash in the AUTH payload, could trigger an assertion leading to denial-of-service. The daemon aborts and restarts; continued exploitation causes sustained denial of service. Remote code execution is not possible. X.509 certificate verifications of the remote IKE peer are not affected.Show less

Libreswan, via the function RSA_authenticate_hash_signature_raw_rsa(), did not correctly verify the length of the authentication hash when the SIG payload of an IKEv1 packet was encoded using PKCS #1 RSA Encryption as per RFC 2313. A remote attacker can use a variation on the Bleichenbacher attack to forge the SIG payload when small public exponents are being used (e.g., e=3), which could lead to impersonation. Additionally, a remote attacker, by encoding a shorter than expected hash in the SIG payload, could trigger an assertion leading to denial-of-service. The daemon aborts and restarts; continued exploitation causes sustained denial of service. Remote code execution is not possible. X.509 certificate verifications of remote IKE peers are not affected.Show less

An invalidly formatted IKEv2 fragment causes the Libreswan pluto daemon to crash and restart. Continued exploitation would cause a denial of service. The function reassemble_v2_incoming_fragments() would ignore unknown outer payloads but still store these in a fixed size array msg_digest.digest[PAYLIMIT]. An off-by-one error in the assertion PASSERT(logger, md->digest_roof < elemsof(md->digest)) causes the daemon to abort. No remote code execution is possible. Any configuration that allows IKEv2 connections that do not set fragmentation=no are vulnerable. IKEv1 is not affected.Show less

In the Linux kernel, the following vulnerability has been resolved: blk-wbt: remove WARN_ON_ONCE from wbt_init_enable_default() wbt_init_enable_default() uses WARN_ON_ONCE to check for failures from wbt_alloc() and wbt_init(). However, both are expected failure paths: - wbt_alloc() can return NULL under memory pressure (-ENOMEM) - wbt_init() can fail with -EBUSY if wbt is already registered syzbot triggers this by injecting memory allocation failures during MTD partition creation via ioctl(BLKPG), causing a spurious warning. wbt_init_enable_default() is a best-effort initialization called from blk_register_queue() with a void return type. Failure simply means the disk operates without writeback throttling, which is harmless. Replace WARN_ON_ONCE with plain if-checks, consistent with how wbt_set_lat() in the same file already handles these failures. Add a pr_warn() for the wbt_init() failure to retain diagnostic information without triggering a full stack trace.Show less

In the Linux kernel, the following vulnerability has been resolved: net: phonet: do not BUG_ON() in pn_socket_autobind() on failed bind syzbot reported a kernel BUG triggered from pn_socket_sendmsg() via pn_socket_autobind(): kernel BUG at net/phonet/socket.c:213! RIP: 0010:pn_socket_autobind net/phonet/socket.c:213 [inline] RIP: 0010:pn_socket_sendmsg+0x240/0x250 net/phonet/socket.c:421 Call Trace: sock_sendmsg_nosec+0x112/0x150 net/socket.c:797 __sock_sendmsg net/socket.c:812 [inline] __sys_sendto+0x402/0x590 net/socket.c:2280 ... pn_socket_autobind() calls pn_socket_bind() with port 0 and, on -EINVAL, assumes the socket was already bound and asserts that the port is non-zero: err = pn_socket_bind(sock, ..., sizeof(struct sockaddr_pn)); if (err != -EINVAL) return err; BUG_ON(!pn_port(pn_sk(sock->sk)->sobject)); return 0; /* socket was already bound */ However pn_socket_bind() also returns -EINVAL when sk->sk_state is not TCP_CLOSE, even when the socket has never been bound and pn_port() is still 0. In that case the BUG_ON() fires and panics the kernel from a user-triggerable path. Treat the "bind returned -EINVAL but pn_port() is still 0" case as a regular error and propagate -EINVAL to the caller instead of crashing. Existing callers already translate a non-zero return from pn_socket_autobind() into -ENOBUFS/-EAGAIN, so returning -EINVAL here only changes behaviour from panic to a normal errno.Show less

In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Wrap DCN32 phantom-plane allocation in DC_RUN_WITH_PREEMPTION_ENABLED [Why] dcn32_validate_bandwidth() wraps dcn32_internal_validate_bw() with DC_FP_START()/DC_FP_END(). In x86 non-RT, DC_FP_START takes fpregs_lock(), which disables local softirqs. The DML1 path through dcn32_enable_phantom_plane() calls kvzalloc() to allocate ~335 KiB for dc_plane_state. This triggers the vmalloc path, which calls BUG_ON(in_interrupt()) because it's invoked within the FPU-enabled (softirq disabled) region, leading to a kernel crash. [How] Wrap the dc_state_create_phantom_plane() call with the DC_RUN_WITH_PREEMPTION_ENABLED() macro to allow preemption during this memory allocation. (cherry picked from commit 885ccbef7b94a8b38f69c4211c679021aa27ad11)Show less

CWE-617 Reachable Assertion vulnerability exists that could allow an authenticated attacker to trigger a denial-of-service condition, impacting system availability when a specially crafted request is sent to a vulnerable network-exposed service.Show less

In EmberZNet v9.0.2 and earlier, malformed Color Control messages can lead to asserts that terminate the process. These messages must come from a device that has already joined the network. Only devices supporting the Color Control cluster may be impacted.Show less

In EmberZNet v9.0.2 and earlier, malformed Color Control messages can lead to asserts that terminate the process. These messages must come from a device that has already joined the network. Only devices supporting the Color Control cluster may be impacted.Show less

In the Linux kernel, the following vulnerability has been resolved: accel/ethosu: reject NPU_OP_RESIZE commands from userspace NPU_OP_RESIZE is a U85-only command that the driver does not yet implement. The existing WARN_ON(1) placeholder fires unconditionally whenever userspace submits this command via DRM_IOCTL_ETHOSU_GEM_CREATE, causing unbounded kernel log spam. If panic_on_warn is set the kernel panics, giving any unprivileged user with access to the DRM device a trivial denial-of-service primitive. Replace the WARN_ON(1) with an explicit -EINVAL return so the ioctl rejects the command before it reaches hardware.Show less