NULL Pointer Dereference

A NULL pointer dereference in the SQLite Session Extension in SQLite 3.53.1 and SQLite trunk builds before check-in e807d4e3798efd53 allows an attacker who can supply a malformed changeset blob to cause a denial of service. The issue occurs when sqlite3changeset_apply_v3() applies a corrupt changeset and reaches sqlite3_value_type() with a NULL sqlite3_value pointer.Show less

The Dhara flash translation layer disk driver (drivers/disk/ftl_dhara.c) implemented the dhara_nand_ callbacks so that, on a flash error, the error code was written unconditionally through the caller-supplied dhara_error_t err pointer (e.g. *err = DHARA_E_ECC in dhara_nand_read, and similar in dhara_nand_erase/prog/copy). The upstream Dhara library calls these callbacks with err == NULL along its journal-resume binary search: find_last_checkblock() invokes find_checkblock(j, mid, &found, NULL), which forwards the NULL pointer into dhara_nand_read(). This path runs during disk_ftl_access_init() -> dhara_map_resume() whenever the FTL disk is mounted/initialised. If a flash read error (uncorrectable ECC, bad block, controller error) occurs on one of the probed checkpoint pages, the driver dereferences and writes to NULL, faulting the kernel (denial of service). The trigger is conditioned on the NAND medium content/health, which can be influenced by media wear, induced faults, or a corrupted/crafted on-flash image. The fix routes all error assignments through the library's NULL-safe dhara_set_error() helper. Affects Zephyr v4.4.0, where the driver was introduced.Show less

DNG SDK versions 1.7.1 2536 and earlier are affected by a NULL Pointer Dereference vulnerability that could result in an application denial-of-service. An attacker could exploit this vulnerability to crash the application, leading to a denial-of-service condition. Exploitation of this issue requires user interaction in that a victim must open a malicious file.Show less

A flaw has been found in GPAC 26.02.0. This affects the function nhmldump_send_frame of the file src/filters/write_nhml.c of the component Media File Handler. Executing a manipulation can lead to null pointer dereference. The attack requires local access. The exploit has been published and may be used. This patch is called bd1d94e70e3bef364c07c5a1d94eca5c9f56e160. A patch should be applied to remediate this issue. The project explains: "I would consider most of these more as bugs than vulns but anyway they're good to fix".Show less

The MAX32xxx USB device controller driver (drivers/usb/udc/udc_max32.c, compatible adi_max32_usbhs) dereferenced an endpoint buffer in its OUT and IN transfer-completion handlers without checking it for NULL. udc_event_xfer_out_done() called net_buf_add(buf, ep_request->actlen) immediately after buf = udc_buf_get(ep_cfg), where udc_buf_get() returns NULL when the endpoint FIFO is empty. A transfer-completion event is queued from interrupt context and processed asynchronously by the driver thread; between queuing and processing, the endpoint FIFO can be drained by host-controlled control flow — in particular udc_setup_received() drains the EP0 OUT/IN FIFOs whenever a new SETUP packet arrives, and dequeue/disable/purge paths drain it likewise. A USB host that aborts an in-flight EP0 control transfer with a new SETUP packet (legal USB behavior) can therefore cause a stale XFER_OUT_DONE event to be processed against an empty FIFO, producing net_buf_add(NULL, ...), a near-NULL pointer dereference that faults and crashes the device. No authentication is required; the attacker is the USB host the device is connected to (physical bus access). Impact is denial of service (device crash). The defect was introduced when the MAX32 UDC driver was added and shipped in Zephyr v4.4.0. The fix adds NULL-buffer checks that return early with UDC_EVT_ERROR/-ENOBUFS in both the OUT-done and IN-done handlers.Show less

A null pointer dereference vulnerability in WatchGuard Fireware OS may allow a remote unauthenticated attacker to create a denial-of-service (DoS) condition by sending specially crafted IKEv2 messages. This vulnerability affects both the Mobile User VPN with IKEv2 and the Branch Office VPN using IKEv2 when configured with a dynamic gateway peer. This vulnerability affects Fireware OS 11.10.2 up to and including 11.12.4_Update1, 12.0 up to and including 12.12 and 2025.1 up to and including 2026.2Show less

In the Linux kernel, the following vulnerability has been resolved: net: rds: clear i_sends on setup unwind The RDS IB connection teardown path is written so it can run during partial startup and on repeated shutdown attempts. It uses NULL pointers to distinguish resources that are still owned from resources that have already been released. When rds_ib_setup_qp() fails after allocating i_sends but before allocating i_recvs, the sends_out path frees i_sends without clearing the pointer. A later shutdown pass can still treat that stale pointer as a live send ring allocation. Clear i_sends after vfree() in the error unwind path so the existing shutdown logic continues to use the correct ownership state.Show less

In the Linux kernel, the following vulnerability has been resolved: ASoC: wm_adsp: Fix NULL dereference when removing firmware controls In wm_adsp_control_remove() check that the priv pointer is not NULL before attempting to cleanup what it points to. When cs_dsp creates a control it calls wm_adsp_control_add_cb() so that wm_adsp can create its own private control data. There are two cases where private data is not created: 1. The control is a SYSTEM control, so an ALSA control is not created. 2. The codec driver has registered a control_add() callback that hides the control, so wm_adsp_control_add() is not called. When cs_dsp_remove destroys its control list it calls wm_adsp_control_remove() for each control. But wm_adsp_control_remove() was attempting to cleanup the private data pointed to by cs_ctl->priv without checking the pointer for NULL.Show less

In the Linux kernel, the following vulnerability has been resolved: ASoC: SDCA: fix NULL pointer dereference in sdca_dev_unregister_functions sdca_dev_unregister_functions() iterates over all SDCA function descriptors and calls sdca_dev_unregister() on each func_dev without checking for NULL. When a function registration has failed partway through, or the device cleanup races with probe deferral, func_dev entries may be NULL, leading to a kernel oops: BUG: kernel NULL pointer dereference, address: 0000000000000040 RIP: 0010:device_del+0x1e/0x3e0 Call Trace: sdca_dev_unregister_functions+0x37/0x60 [snd_soc_sdca] release_nodes+0x35/0xb0 devres_release_all+0x90/0x100 device_unbind_cleanup+0xe/0x80 device_release_driver_internal+0x1c1/0x200 bus_remove_device+0xc6/0x130 device_del+0x161/0x3e0 device_unregister+0x17/0x60 sdw_delete_slave+0xb6/0xd0 [soundwire_bus] sdw_bus_master_delete+0x1e/0x50 [soundwire_bus] ... sof_probe_work+0x19/0x30 [snd_sof] This was observed on a Lenovo ThinkPad X1 Carbon G14 (Panther Lake) with the SOF audio driver probe failing due to missing Panther Lake firmware, causing the subsequent cleanup of SoundWire devices to trigger the crash. Fix this with three changes: 1) Add a NULL guard in sdca_dev_unregister() so that callers do not need to pre-validate the pointer (defense in depth). 2) In sdca_dev_unregister_functions(), skip NULL func_dev entries and clear func_dev to NULL after unregistration, making the function idempotent and safe against double-invocation. 3) In sdca_dev_register_functions(), roll back all previously registered functions when a later one fails, so the function array is never left in a partially-populated state.Show less

In the Linux kernel, the following vulnerability has been resolved: net: bonding: fix NULL pointer dereference in bond_do_ioctl() In bond_do_ioctl(), slave_dev is obtained via __dev_get_by_name() which can return NULL if the requested interface name does not exist. However, the subsequent slave_dbg() call is placed before the NULL check: slave_dev = __dev_get_by_name(net, ifr->ifr_slave); slave_dbg(bond_dev, slave_dev, "slave_dev=%p:\n", slave_dev); //here if (!slave_dev) return -ENODEV; The slave_dbg() macro expands to netdev_dbg(bond_dev, "(slave %s): " fmt, (slave_dev)->name, ...) which unconditionally dereferences slave_dev->name before the NULL check is performed. This results in a NULL pointer dereference kernel oops when a user calls bonding ioctl (e.g. SIOCBONDENSLAVE, SIOCBONDRELEASE, etc.) with a non-existent slave interface name. This is reachable from userspace via the bonding ioctl interface with CAP_NET_ADMIN capability, making it a potential local denial-of-service vector. Fix by moving the slave_dbg() call after the NULL check.Show less

In Modem, there is a possible system crash due to improper input validation. This could lead to remote denial of service, if a UE has connected to a rogue base station controlled by the attacker, with no additional execution privileges needed. User interaction is not needed for exploitation. Patch ID: MOLY01826924; Issue ID: MSV-7301.Show less

Woodpecker before 3.15.0 registers the /api/orgs/lookup/*org_full_name endpoint without authentication middleware, and the LookupOrg handler unconditionally dereferences the session user (user.ForgeID, via ForgeFromUser) when selecting the forge to query. For an unauthenticated request session.User returns nil, so any unauthenticated HTTP request triggers a NULL pointer dereference in the handler. The panic is recovered by gin recovery middleware and the server continues serving (returning HTTP 500), but each request writes a multi-line panic stack trace to the error log. A low-bandwidth unauthenticated attacker can repeatedly probe the endpoint to flood the logs (about 37 lines per request), inflating disk usage and downstream log-ingestion cost and burying legitimate log events.Show less

mcumgr_serial_process_frag() in subsys/mgmt/mcumgr/transport/src/serial_util.c calls net_buf_reset() on the result of smp_packet_alloc() before checking it for NULL. smp_packet_alloc() uses net_buf_alloc(K_NO_WAIT) against the shared MCUmgr packet pool (CONFIG_MCUMGR_TRANSPORT_NETBUF_COUNT, default 4), which returns NULL when the pool is exhausted. In default builds the __ASSERT_NO_MSG in net_buf_reset is a no-op, so net_buf_simple_reset writes through the NULL pointer (buf->len = 0; buf->data = buf->__buf), causing a fault/crash. The fragment data reaches this code from attacker-controlled bytes on the MCUmgr serial/UART/shell-console transports (smp_uart.c, smp_raw_uart.c, smp_shell.c), and a fresh buffer is allocated at the start of essentially every new packet. An attacker on the serial/console link can flood the transport to drive the 4-entry buffer pool to exhaustion and induce the NULL dereference, crashing the device (denial of service). The defect was introduced after the original MCUmgr rework and shipped in Zephyr v4.4.0. The fix moves the NULL check ahead of net_buf_reset.Show less

JavaScript::Minifier::XS versions before 0.16 for Perl crash with a NULL pointer dereference when the first meaningful token of the input is a slash. The regexp versus division disambiguator in JsTokenizeString (XS.xs) inspects the previous token's last byte to choose between a regexp literal and a division operator. When a slash is the first meaningful token, with the start of input or only whitespace and comments before it, there is no valid preceding token: the walk back over whitespace and comment nodes runs off the head of the node list to NULL, and the byte lookup reads through a NULL contents pointer at an underflowed length index. The following identifier check dereferences the same NULL pointer. The crash is reachable through the public minify() API, so input as small as a single slash byte crashes the calling process. A service that minifies untrusted or third-party JavaScript can be crashed by a remote request, causing denial of service.Show less

In the Linux kernel, the following vulnerability has been resolved: agp/amd64: Fix broken error propagation in agp_amd64_probe() A NULL pointer dereference was observed in the AMD64 AGP driver when running in a virtualized environment (e.g. qemu/kvm) without a physical AMD northbridge. The crash occurs in amd64_fetch_size() when attempting to dereference the pointer returned by node_to_amd_nb(0). The root cause of this crash is broken error propagation in agp_amd64_probe(): When no AMD northbridges are found, cache_nbs() correctly returns -ENODEV. However, the probe function erroneously checks the return value against exactly -1, rather than < 0. As a result, the hardware absence error is masked, allowing the driver to improperly proceed with initialization. It eventually calls agp_add_bridge(), which invokes amd64_fetch_size(). Since the hardware does not exist, node_to_amd_nb(0) returns NULL, leading to a General Protection Fault (GPF) when accessing its ->misc member. Fix the issue by correcting the error check in agp_amd64_probe() to abort properly when cache_nbs() returns any negative error code. This prevents the driver from erroneously proceeding without hardware, thereby avoiding the subsequent NULL pointer dereference at its source.Show less