NULL Pointer Dereference

In the Linux kernel, the following vulnerability has been resolved: tpm: Use auth only after NULL check in tpm_buf_check_hmac_response() Dereference auth after NULL check in tpm_buf_check_hmac_response(). Otherwise, unless tpm2_sessions_init() was called, a call can cause NULL dereference, when TCG_TPM2_HMAC is enabled. [jarkko: adjusted the commit message.]Show less

In the Linux kernel, the following vulnerability has been resolved: io_uring: fix error pbuf checking Syz reports a problem, which boils down to NULL vs IS_ERR inconsistent error handling in io_alloc_pbuf_ring(). KASAN: null-ptr-deref in range [0x0000000000000000-0x0000000000000007] RIP: 0010:__io_remove_buffers+0xac/0x700 io_uring/kbuf.c:341 Call Trace: <TASK> io_put_bl io_uring/kbuf.c:378 [inline] io_destroy_buffers+0x14e/0x490 io_uring/kbuf.c:392 io_ring_ctx_free+0xa00/0x1070 io_uring/io_uring.c:2613 io_ring_exit_work+0x80f/0x8a0 io_uring/io_uring.c:2844 process_one_work kernel/workqueue.c:3231 [inline] process_scheduled_works+0xa2c/0x1830 kernel/workqueue.c:3312 worker_thread+0x86d/0xd40 kernel/workqueue.c:3390 kthread+0x2f0/0x390 kernel/kthread.c:389 ret_from_fork+0x4b/0x80 arch/x86/kernel/process.c:147 ret_from_fork_asm+0x1a/0x30 arch/x86/entry/entry_64.S:244Show less

In the Linux kernel, the following vulnerability has been resolved: tty: serial: ma35d1: Add a NULL check for of_node The pdev->dev.of_node can be NULL if the "serial" node is absent. Add a NULL check to return an error in such cases.Show less

In the Linux kernel, the following vulnerability has been resolved: s390/mm: Add NULL pointer check to crst_table_free() base_crst_free() crst_table_free() used to work with NULL pointers before the conversion to ptdescs. Since crst_table_free() can be called with a NULL pointer (error handling in crst_table_upgrade() add an explicit check. Also add the same check to base_crst_free() for consistency reasons. In real life this should not happen, since order two GFP_KERNEL allocations will not fail, unless FAIL_PAGE_ALLOC is enabled and used.Show less

In the Linux kernel, the following vulnerability has been resolved: bpf: mark bpf_dummy_struct_ops.test_1 parameter as nullable Test case dummy_st_ops/dummy_init_ret_value passes NULL as the first parameter of the test_1() function. Mark this parameter as nullable to make verifier aware of such possibility. Otherwise, NULL check in the test_1() code: SEC("struct_ops/test_1") int BPF_PROG(test_1, struct bpf_dummy_ops_state *state) { if (!state) return ...; ... access state ... } Might be removed by verifier, thus triggering NULL pointer dereference under certain conditions.Show less

In the Linux kernel, the following vulnerability has been resolved: fs: don't misleadingly warn during thaw operations The block device may have been frozen before it was claimed by a filesystem. Concurrently another process might try to mount that frozen block device and has temporarily claimed the block device for that purpose causing a concurrent fs_bdev_thaw() to end up here. The mounter is already about to abort mounting because they still saw an elevanted bdev->bd_fsfreeze_count so get_bdev_super() will return NULL in that case. For example, P1 calls dm_suspend() which calls into bdev_freeze() before the block device has been claimed by the filesystem. This brings bdev->bd_fsfreeze_count to 1 and no call into fs_bdev_freeze() is required. Now P2 tries to mount that frozen block device. It claims it and checks bdev->bd_fsfreeze_count. As it's elevated it aborts mounting. In the meantime P3 called dm_resume(). P3 sees that the block device is already claimed by a filesystem and calls into fs_bdev_thaw(). P3 takes a passive reference and realizes that the filesystem isn't ready yet. P3 puts itself to sleep to wait for the filesystem to become ready. P2 now puts the last active reference to the filesystem and marks it as dying. P3 gets woken, sees that the filesystem is dying and get_bdev_super() fails.Show less

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: ISO: Check socket flag instead of hcon This fixes the following Smatch static checker warning: net/bluetooth/iso.c:1364 iso_sock_recvmsg() error: we previously assumed 'pi->conn->hcon' could be null (line 1359) net/bluetooth/iso.c 1347 static int iso_sock_recvmsg(struct socket *sock, struct msghdr *msg, 1348 size_t len, int flags) 1349 { 1350 struct sock *sk = sock->sk; 1351 struct iso_pinfo *pi = iso_pi(sk); 1352 1353 BT_DBG("sk %p", sk); 1354 1355 if (test_and_clear_bit(BT_SK_DEFER_SETUP, &bt_sk(sk)->flags)) { 1356 lock_sock(sk); 1357 switch (sk->sk_state) { 1358 case BT_CONNECT2: 1359 if (pi->conn->hcon && ^^^^^^^^^^^^^^ If ->hcon is NULL 1360 test_bit(HCI_CONN_PA_SYNC, &pi->conn->hcon->flags)) { 1361 iso_conn_big_sync(sk); 1362 sk->sk_state = BT_LISTEN; 1363 } else { --> 1364 iso_conn_defer_accept(pi->conn->hcon); ^^^^^^^^^^^^^^ then we're toast 1365 sk->sk_state = BT_CONFIG; 1366 } 1367 release_sock(sk); 1368 return 0; 1369 case BT_CONNECTED: 1370 if (test_bit(BT_SK_PA_SYNC,Show less

In the Linux kernel, the following vulnerability has been resolved: virtio-pci: Check if is_avq is NULL [bug] In the virtio_pci_common.c function vp_del_vqs, vp_dev->is_avq is involved to determine whether it is admin virtqueue, but this function vp_dev->is_avq may be empty. For installations, virtio_pci_legacy does not assign a value to vp_dev->is_avq. [fix] Check whether it is vp_dev->is_avq before use. [test] Test with virsh Attach device Before this patch, the following command would crash the guest system After applying the patch, everything seems to be working fine.Show less

In the Linux kernel, the following vulnerability has been resolved: wifi: rtw89: fw: scan offload prohibit all 6 GHz channel if no 6 GHz sband We have some policy via BIOS to block uses of 6 GHz. In this case, 6 GHz sband will be NULL even if it is WiFi 7 chip. So, add NULL handling here to avoid crash.Show less

In the Linux kernel, the following vulnerability has been resolved: ice: Don't process extts if PTP is disabled The ice_ptp_extts_event() function can race with ice_ptp_release() and result in a NULL pointer dereference which leads to a kernel panic. Panic occurs because the ice_ptp_extts_event() function calls ptp_clock_event() with a NULL pointer. The ice driver has already released the PTP clock by the time the interrupt for the next external timestamp event occurs. To fix this, modify the ice_ptp_extts_event() function to check the PTP state and bail early if PTP is not ready.Show less

In the Linux kernel, the following vulnerability has been resolved: drm/nouveau: fix null pointer dereference in nouveau_connector_get_modes In nouveau_connector_get_modes(), the return value of drm_mode_duplicate() is assigned to mode, which will lead to a possible NULL pointer dereference on failure of drm_mode_duplicate(). Add a check to avoid npd.Show less

In the Linux kernel, the following vulnerability has been resolved: clk: sunxi-ng: common: Don't call hw_to_ccu_common on hw without common In order to set the rate range of a hw sunxi_ccu_probe calls hw_to_ccu_common() assuming all entries in desc->ccu_clks are contained in a ccu_common struct. This assumption is incorrect and, in consequence, causes invalid pointer de-references. Remove the faulty call. Instead, add one more loop that iterates over the ccu_clks and sets the rate range, if required.Show less

In the Linux kernel, the following vulnerability has been resolved: s390/dasd: Fix invalid dereferencing of indirect CCW data pointer Fix invalid dereferencing of indirect CCW data pointer in dasd_eckd_dump_sense() that leads to a kernel panic in error cases. When using indirect addressing for DASD CCWs (IDAW) the CCW CDA pointer does not contain the data address itself but a pointer to the IDAL. This needs to be translated from physical to virtual as well before using it. This dereferencing is also used for dasd_page_cache and also fixed although it is very unlikely that this code path ever gets used.Show less

In the Linux kernel, the following vulnerability has been resolved: drm/xe: Check pat.ops before dumping PAT settings We may leave pat.ops unset when running on brand new platform or when running as a VF. While the former is unlikely, the latter is valid (future) use case and will cause NPD when someone will try to dump PAT settings by debugfs. It's better to check pointer to pat.ops instead of specific .dump hook, as we have this hook always defined for every .ops variant.Show less

In the Linux kernel, the following vulnerability has been resolved: ASoC: fsl-asoc-card: set priv->pdev before using it priv->pdev pointer was set after being used in fsl_asoc_card_audmux_init(). Move this assignment at the start of the probe function, so sub-functions can correctly use pdev through priv. fsl_asoc_card_audmux_init() dereferences priv->pdev to get access to the dev struct, used with dev_err macros. As priv is zero-initialised, there would be a NULL pointer dereference. Note that if priv->dev is dereferenced before assignment but never used, for example if there is no error to be printed, the driver won't crash probably due to compiler optimisations.Show less