NULL Pointer Dereference

Ubuntu Linux 6.8, 6.17 and 7.0 contain SAUCE patches with a possible NULL pointer dereference in the handling of AF_INET/AF_INET6 socket mediation. The bug can be triggered by an unprivileged local user. This can lead to a kernel oops.Show less

Ubuntu Linux 6.8, 6.17 and 7.0 contain SAUCE patches with a possible NULL pointer dereference in the handling of AppArmor notifications. The bug can be triggered by an unprivileged local user. This can lead to a kernel oops.Show less

In the Linux kernel, the following vulnerability has been resolved: media: saa7164: add ioremap return checks and cleanups Add checks for ioremap return values in saa7164_dev_setup(). If ioremap for BAR0 or BAR2 fails, release the already allocated PCI memory regions, remove the device from the global list, decrement the device count, and return -ENODEV. This prevents potential null pointer dereferences and ensures proper cleanup on memory mapping failures.Show less

In the Linux kernel, the following vulnerability has been resolved: batman-adv: bla: only purge non-released claims When batadv_bla_purge_claims() goes through the list of claims, it is only traversing the hash list with an rcu_read_lock(). Due to a potential parallel batadv_claim_put(), it can happen that it encounters a claim which was actually in the process of being released+freed by batadv_claim_release(). In this case, backbone_gw is set to NULL before the delayed RCU kfree is started. Calling batadv_bla_claim_get_backbone_gw() is then no longer allowed because it would cause a NULL-ptr derefence. To avoid this, only claims with a valid reference counter must be purged. All others are already taken care of.Show less

In the Linux kernel, the following vulnerability has been resolved: media: rockchip: rkcif: Add missing MUST_CONNECT flag to pads The pads missed checks for connected devices which may a null dereference when the stream is enabled. Unable to handle kernel NULL pointer dereference at virtual address 0000000000000020 pc : rkcif_interface_enable_streams+0x48/0xf0 lr : rkcif_interface_enable_streams+0x44/0xf0 Call trace: rkcif_interface_enable_streams+0x48/0xf0 v4l2_subdev_enable_streams+0x26c/0x3f0 rkcif_stream_start_streaming+0x140/0x278 vb2_start_streaming+0x74/0x188 vb2_core_streamon+0xe0/0x1d8 vb2_ioctl_streamon+0x60/0xa8 v4l_streamon+0x2c/0x40 __video_do_ioctl+0x34c/0x400 video_usercopy+0x2d0/0x800 video_ioctl2+0x20/0x60 v4l2_ioctl+0x48/0x78Show less

In the Linux kernel, the following vulnerability has been resolved: drm/xe/hdcp: Add NULL check for media_gt in intel_hdcp_gsc_check_status() When media GT is disabled via configfs, there is no allocation for media_gt, which is kept as NULL. In such scenario, intel_hdcp_gsc_check_status() results in a kernel pagefault error due to &gt->uc.gsc being evaluated as an invalid memory address. Fix that by introducing a NULL check on media_gt and bailing out early if so. While at it, also drop the NULL check for gsc, since it can't be NULL if media_gt is not NULL. v2: - Get address for gsc only after checking that gt is not NULL. (Shuicheng) - Drop the NULL check for gsc. (Shuicheng) v3: - Add "Fixes" and "Cc: <stable...>" tags. (Matt) (cherry picked from commit bfaf87e84ca3ca3f6e275f9ae56da47a8b55ffd1)Show less

In the Linux kernel, the following vulnerability has been resolved: drm/msm/gem: fix error handling in msm_ioctl_gem_info_get_metadata() msm_ioctl_gem_info_get_metadata() always returns 0 regardless of errors. When copy_to_user() fails or the user buffer is too small, the error code stored in ret is ignored because the function unconditionally returns 0. This causes userspace to believe the ioctl succeeded when it did not. Additionally, kmemdup() can return NULL on allocation failure, but the return value is not checked. This leads to a NULL pointer dereference in the subsequent copy_to_user() call. Add the missing NULL check for kmemdup() and return ret instead of 0. Note that the SET counterpart (msm_ioctl_gem_info_set_metadata) correctly returns ret. Patchwork: https://patchwork.freedesktop.org/patch/714478/Show less

In the Linux kernel, the following vulnerability has been resolved: smb: client: validate dacloffset before building DACL pointers parse_sec_desc(), build_sec_desc(), and the chown path in id_mode_to_cifs_acl() all add the server-supplied dacloffset to pntsd before proving a DACL header fits inside the returned security descriptor. On 32-bit builds a malicious server can return dacloffset near U32_MAX, wrap the derived DACL pointer below end_of_acl, and then slip past the later pointer-based bounds checks. build_sec_desc() and id_mode_to_cifs_acl() can then dereference DACL fields from the wrapped pointer in the chmod/chown rewrite paths. Validate dacloffset numerically before building any DACL pointer and reuse the same helper at the three DACL entry points.Show less

In the Linux kernel, the following vulnerability has been resolved: octeon_ep_vf: add NULL check for napi_build_skb() napi_build_skb() can return NULL on allocation failure. In __octep_vf_oq_process_rx(), the result is used directly without a NULL check in both the single-buffer and multi-fragment paths, leading to a NULL pointer dereference. Add NULL checks after both napi_build_skb() calls, properly advancing descriptors and consuming remaining fragments on failure.Show less

In the Linux kernel, the following vulnerability has been resolved: platform/chrome: cros_ec_typec: Init mutex in Thunderbolt registration cros_typec_register_thunderbolt() missed initializing the `adata->lock` mutex. This leads to a NULL dereference when the mutex is later acquired (e.g. in cros_typec_altmode_work()). Initialize the mutex in cros_typec_register_thunderbolt() to fix the issue.Show less

In the Linux kernel, the following vulnerability has been resolved: RDMA/ocrdma: Don't NULL deref uctx on errors in ocrdma_copy_pd_uresp() Sashiko points out that pd->uctx isn't initialized until late in the function so all these error flow references are NULL and will crash. Use the uctx that isn't NULL.Show less

In the Linux kernel, the following vulnerability has been resolved: pseries/papr-hvpipe: Fix null ptr deref in papr_hvpipe_dev_create_handle() commit 6d3789d347a7 ("papr-hvpipe: convert papr_hvpipe_dev_create_handle() to FD_PREPARE()"), changed the create handle to FD_PREPARE(), but it caused kernel null-ptr-deref because after call to retain_and_null_ptr(src_info), src_info is re-used for adding it to the global list. Getting the following kernel panic in papr_hvpipe_dev_create_handle() when trying to add src_info to the list. Kernel attempted to write user page (0) - exploit attempt? (uid: 0) BUG: Kernel NULL pointer dereference on write at 0x00000000 Faulting instruction address: 0xc0000000001b44a0 Oops: Kernel access of bad area, sig: 11 [#1] ... Call Trace: papr_hvpipe_dev_ioctl+0x1f4/0x48c (unreliable) sys_ioctl+0x528/0x1064 system_call_exception+0x128/0x360 system_call_vectored_common+0x15c/0x2ec Now, the error handling with FD_PREPARE's file cleanup and __free(kfree) auto cleanup is getting too convoluted. This is mainly because we need to ensure only 1 user get the srcID handle. To simplify this, we allocate prepare the src_info in the beginning and add it to the global list under a spinlock after checking that no duplicates exist. This simplify the error handling where if the FD_ADD fails, we can simply remove the src_info from the list and consume any pending msg in hvpipe to be cleared, after src_info became visible in the global list.Show less

In the Linux kernel, the following vulnerability has been resolved: RDMA/rxe: Reject non-8-byte ATOMIC_WRITE payloads atomic_write_reply() at drivers/infiniband/sw/rxe/rxe_resp.c unconditionally dereferences 8 bytes at payload_addr(pkt): value = *(u64 *)payload_addr(pkt); check_rkey() previously accepted an ATOMIC_WRITE request with pktlen == resid == 0 because the length validation only compared pktlen against resid. A remote initiator that sets the RETH length to 0 therefore reaches atomic_write_reply() with a zero-byte logical payload, and the responder reads sizeof(u64) bytes from past the logical end of the packet into skb->head tailroom, then writes those 8 bytes into the attacker's MR via rxe_mr_do_atomic_write(). That is a remote disclosure of 4 bytes of kernel tailroom per probe (the other 4 bytes are the packet's own trailing ICRC). IBA oA19-28 defines ATOMIC_WRITE as exactly 8 bytes. Anything else is protocol-invalid. Hoist a strict length check into check_rkey() so the responder never reaches the unchecked dereference, and keep the existing WRITE-family length logic for the normal RDMA WRITE path. Reproduced on mainline with an unmodified rxe driver: a sustained zero-length ATOMIC_WRITE probe repeatedly leaks adjacent skb head-buffer bytes into the attacker's MR, including recognisable kernel strings and partial kernel-direct-map pointer words. With this patch applied the responder rejects the PDU and the MR stays all-zero.Show less

In the Linux kernel, the following vulnerability has been resolved: net: stmmac: Prevent NULL deref when RX memory exhausted The CPU receives frames from the MAC through conventional DMA: the CPU allocates buffers for the MAC, then the MAC fills them and returns ownership to the CPU. For each hardware RX queue, the CPU and MAC coordinate through a shared ring array of DMA descriptors: one descriptor per DMA buffer. Each descriptor includes the buffer's physical address and a status flag ("OWN") indicating which side owns the buffer: OWN=0 for CPU, OWN=1 for MAC. The CPU is only allowed to set the flag and the MAC is only allowed to clear it, and both must move through the ring in sequence: thus the ring is used for both "submissions" and "completions." In the stmmac driver, stmmac_rx() bookmarks its position in the ring with the `cur_rx` index. The main receive loop in that function checks for rx_descs[cur_rx].own=0, gives the corresponding buffer to the network stack (NULLing the pointer), and increments `cur_rx` modulo the ring size. After the loop exits, stmmac_rx_refill(), which bookmarks its position with `dirty_rx`, allocates fresh buffers and rearms the descriptors (setting OWN=1). If it fails any allocation, it simply stops early (leaving OWN=0) and will retry where it left off when next called. This means descriptors have a three-stage lifecycle (terms my own): - `empty` (OWN=1, buffer valid) - `full` (OWN=0, buffer valid and populated) - `dirty` (OWN=0, buffer NULL) But because stmmac_rx() only checks OWN, it confuses `full`/`dirty`. In the past (see 'Fixes:'), there was a bug where the loop could cycle `cur_rx` all the way back to the first descriptor it dirtied, resulting in a NULL dereference when mistaken for `full`. The aforementioned commit resolved that *specific* failure by capping the loop's iteration limit at `dma_rx_size - 1`, but this is only a partial fix: if the previous stmmac_rx_refill() didn't complete, then there are leftover `dirty` descriptors that the loop might encounter without needing to cycle fully around. The current code therefore panics (see 'Closes:') when stmmac_rx_refill() is memory-starved long enough for `cur_rx` to catch up to `dirty_rx`. Fix this by explicitly checking, before advancing `cur_rx`, if the next entry is dirty; exit the loop if so. This prevents processing of the final, used descriptor until stmmac_rx_refill() succeeds, but fully prevents the `cur_rx == dirty_rx` ambiguity as the previous bugfix intended: so remove the clamp as well. Since stmmac_rx_zc() is a copy-paste-and-tweak of stmmac_rx() and the code structure is identical, any fix to stmmac_rx() will also need a corresponding fix for stmmac_rx_zc(). Therefore, apply the same check there. In stmmac_rx() (not stmmac_rx_zc()), a related bug remains: after the MAC sets OWN=0 on the final descriptor, it will be unable to send any further DMA-complete IRQs until it's given more `empty` descriptors. Currently, the driver simply *hopes* that the next stmmac_rx_refill() succeeds, risking an indefinite stall of the receive process if not. But this is not a regression, so it can be addressed in a future change.Show less

pam_usb provides hardware authentication for Linux using ordinary removable media. Prior to 0.8.7, src/device.c passed the return values of udisks_drive_get_serial(), udisks_drive_get_vendor(), and udisks_drive_get_model() directly to strcmp() without NULL checks. The GIO/UDisks API documentation states these accessors can return NULL for devices that do not expose the corresponding field. Passing NULL to strcmp() is undefined behaviour (typically a SIGSEGV). This vulnerability is fixed in 0.8.7.Show less

Function calls to WOSCommonUtil.dll!WOSSysInfoGetDeviceInterface() in various DLLs (i.e., WOSProfileMgrModule.dll, WOSWebDavModule.dll) can return a NULL pointer (i.e., when no user is logged into the Triofox Server Agent Management Console). The returned NULL pointer is not checked before being dereferenced.Show less

When processing a request with a URL path starting with /status or /sysinfo, WOSHttpStatusModule.dll is to be loaded to handle such URL patterns. The WOSBin_LoadHttpModule function in the dll would be called to set up a "module" object for that module. However, WOSHttpStatusModule.dll is not present in the installation. As a result, a function pointer to WOSBin_LoadHttpModule (which would have been in the export table in WOSHttpStatusModule.dll) is set to NULL, resulting in calling a function at address 0.Show less

pam_usb provides hardware authentication for Linux using ordinary removable media. Prior to 0.9.1, src/log.c contains a process-wide static pointer that is written on every PAM invocation with the address of a stack-local variable. This violates the PAM re-entrancy requirement and creates a data race when the PAM stack is invoked concurrently from multiple threads. This vulnerability is fixed in 0.9.1.Show less