Improper Resource Shutdown or Release

There exists a vulnerability in Quick Share/Nearby, where an attacker can force a victim to stay connected to a temporary hotspot created for the sharing. As part of the sequence of packets in a Quick Share connection over Bluetooth, the attacker forces the victim to connect to the attacker’s WiFi network and then sends an OfflineFrame that crashes Quick Share. This makes the Wifi connection to the attacker’s network last, instead of returning to the old network when the Quick Share session completes, allowing the attacker to be a MiTM. We recommend upgrading to version 1.0.1724.0 of Quick Share or aboveShow less

RMQTT Broker 0.4.0 is vulnerable to Denial of Service (DoS) due to improper session resource management. An attacker can exhaust system memory and crash the daemon by establishing and maintaining a vast number of long-lived malicious publish/subscribe sessions.Show less

A bug exists in the API, mesh_node_power_off(), which fails to copy the contents of the Replay Protection List (RPL) from RAM to NVM before powering down, resulting in the ability to replay unsaved messages. Note that as of June 2024, the Gecko SDK was renamed to the Simplicity SDK, and the versioning scheme was changed from Gecko SDK vX.Y.Z to Simplicity SDK YYYY.MM.Patch#.Show less

A vulnerability classified as problematic has been found in Victor Zsviot Camera 8.26.31. This affects an unknown part of the component MQTT Packet Handler. The manipulation leads to denial of service. It is possible to initiate the attack remotely. The exploit has been disclosed to the public and may be used. The identifier VDB-265077 was assigned to this vulnerability. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.Show less

A vulnerability classified as critical was found in Contemporary Control System BASrouter BACnet BASRT-B 2.7.2. This vulnerability affects unknown code of the component Application Protocol Data Unit. The manipulation leads to denial of service. The attack can be initiated remotely. The exploit has been disclosed to the public and may be used. VDB-263890 is the identifier assigned to this vulnerability. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.Show less

The 'control' in Parrot ANAFI USA firmware 1.10.4 does not check the MAV_MISSION_TYPE(0, 1, 2, 255), which allows attacker to cut off the connection between a controller and the drone by sending MAVLink MISSION_COUNT command with a wrong MAV_MISSION_TYPE.Show less

In the Linux kernel, the following vulnerability has been resolved: gpio: mockup: Fix potential resource leakage when register a chip If creation of software node fails, the locally allocated string array is left unfreed. Free it on error path.Show less

A vulnerability classified as critical has been found in Contemporary Controls BASrouter BACnet BASRT-B 2.7.2. Affected is an unknown function of the component Device-Communication-Control Service. The manipulation with the input 55ff0500370015f30104025506110afb7519035d0841e4bece257b6acfc71f leads to denial of service. The exploit has been disclosed to the public and may be used. The identifier of this vulnerability is VDB-262224. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.Show less

Vulnerability in the MySQL Server product of Oracle MySQL (component: Server: DML). Supported versions that are affected are 8.0.34 and prior. Easily exploitable vulnerability allows high privileged attacker with network access via multiple protocols to compromise MySQL Server. Successful attacks of this vulnerability can result in unauthorized ability to cause a hang or frequently repeatable crash (complete DOS) of MySQL Server. CVSS 3.1 Base Score 4.9 (Availability impacts). CVSS Vector: (CVSS:3.1/AV:N/AC:L/PR:H/UI:N/S:U/C:N/I:N/A:H).Show less

Vulnerability in the Oracle Database Sharding component of Oracle Database Server. Supported versions that are affected are 19.3-19.22 and 21.3-21.13. Easily exploitable vulnerability allows high privileged attacker having DBA privilege with network access via Oracle Net to compromise Oracle Database Sharding. Successful attacks require human interaction from a person other than the attacker. Successful attacks of this vulnerability can result in unauthorized ability to cause a partial denial of service (partial DOS) of Oracle Database Sharding. CVSS 3.1 Base Score 2.4 (Availability impacts). CVSS Vector: (CVSS:3.1/AV:N/AC:L/PR:H/UI:R/S:U/C:N/I:N/A:L).Show less

** DISPUTED ** A vulnerability classified as problematic has been found in Tuya SDK up to 5.0.x. Affected is an unknown function of the component MQTT Packet Handler. The manipulation leads to denial of service. It is possible to launch the attack remotely. The exploit has been disclosed to the public and may be used. The real existence of this vulnerability is still doubted at the moment. Upgrading to version 5.1.0 is able to address this issue. It is recommended to upgrade the affected component. The identifier of this vulnerability is VDB-260604. NOTE: The vendor explains that a malicious actor would have to crack TLS first or use a legitimate login to initiate the attack.Show less

The Libreswan Project was notified of an issue causing libreswan to restart when using IKEv1 without specifying an esp= line. When the peer requests AES-GMAC, libreswan's default proposal handler causes an assertion failure and crashes and restarts. IKEv2 connections are not affected.Show less

In the Linux kernel, the following vulnerability has been resolved: md: Don't ignore read-only array in md_check_recovery() Usually if the array is not read-write, md_check_recovery() won't register new sync_thread in the first place. And if the array is read-write and sync_thread is registered, md_set_readonly() will unregister sync_thread before setting the array read-only. md/raid follow this behavior hence there is no problem. After commit f52f5c71f3d4 ("md: fix stopping sync thread"), following hang can be triggered by test shell/integrity-caching.sh: 1) array is read-only. dm-raid update super block: rs_update_sbs ro = mddev->ro mddev->ro = 0 -> set array read-write md_update_sb 2) register new sync thread concurrently. 3) dm-raid set array back to read-only: rs_update_sbs mddev->ro = ro 4) stop the array: raid_dtr md_stop stop_sync_thread set_bit(MD_RECOVERY_INTR, &mddev->recovery); md_wakeup_thread_directly(mddev->sync_thread); wait_event(..., !test_bit(MD_RECOVERY_RUNNING, &mddev->recovery)) 5) sync thread done: md_do_sync set_bit(MD_RECOVERY_DONE, &mddev->recovery); md_wakeup_thread(mddev->thread); 6) daemon thread can't unregister sync thread: md_check_recovery if (!md_is_rdwr(mddev) && !test_bit(MD_RECOVERY_NEEDED, &mddev->recovery)) return; -> -> MD_RECOVERY_RUNNING can't be cleared, hence step 4 hang; The root cause is that dm-raid manipulate 'mddev->ro' by itself, however, dm-raid really should stop sync thread before setting the array read-only. Unfortunately, I need to read more code before I can refacter the handler of 'mddev->ro' in dm-raid, hence let's fix the problem the easy way for now to prevent dm-raid regression.Show less

A vulnerability was found in NUUO Camera up to 20240319 and classified as problematic. This issue affects some unknown processing of the file /deletefile.php. The manipulation of the argument filename leads to denial of service. The attack may be initiated remotely. The exploit has been disclosed to the public and may be used. The identifier VDB-258197 was assigned to this vulnerability. NOTE: The vendor was contacted early about this disclosure but did not respond in any way.Show less

A vulnerability in Node.js has been identified, allowing for a Denial of Service (DoS) attack through resource exhaustion when using the fetch() function to retrieve content from an untrusted URL. The vulnerability stems from the fact that the fetch() function in Node.js always decodes Brotli, making it possible for an attacker to cause resource exhaustion when fetching content from an untrusted URL. An attacker controlling the URL passed into fetch() can exploit this vulnerability to exhaust memory, potentially leading to process termination, depending on the system configuration.Show less

CoreWCF is a port of the service side of Windows Communication Foundation (WCF) to .NET Core. If you have a NetFraming based CoreWCF service, extra system resources could be consumed by connections being left established instead of closing or aborting them. There are two scenarios when this can happen. When a client established a connection to the service and sends no data, the service will wait indefinitely for the client to initiate the NetFraming session handshake. Additionally, once a client has established a session, if the client doesn't send any requests for the period of time configured in the binding ReceiveTimeout, the connection is not properly closed as part of the session being aborted. The bindings affected by this behavior are NetTcpBinding, NetNamedPipeBinding, and UnixDomainSocketBinding. Only NetTcpBinding has the ability to accept non local connections. The currently supported versions of CoreWCF are v1.4.x and v1.5.x. The fix can be found in v1.4.2 and v1.5.2 of the CoreWCF packages. Users are advised to upgrade. There are no workarounds for this issue. Show less

** UNSUPPORTED WHEN ASSIGNED ** A vulnerability was found in AOL AIM Triton 1.0.4. It has been declared as problematic. This vulnerability affects unknown code of the component Invite Handler. The manipulation of the argument CSeq leads to denial of service. The attack can be initiated remotely. The exploit has been disclosed to the public and may be used. VDB-256318 is the identifier assigned to this vulnerability. NOTE: This vulnerability only affects products that are no longer supported by the maintainer.Show less