In the Linux kernel, the following vulnerability has been resolved:
drm/i915/gem: Fix Virtual Memory mapping boundaries calculation
Calculating the size of the mapped area as the lesser value
between the requested size...Show moreIn the Linux kernel, the following vulnerability has been resolved:
drm/i915/gem: Fix Virtual Memory mapping boundaries calculation
Calculating the size of the mapped area as the lesser value
between the requested size and the actual size does not consider
the partial mapping offset. This can cause page fault access.
Fix the calculation of the starting and ending addresses, the
total size is now deduced from the difference between the end and
start addresses.
Additionally, the calculations have been rewritten in a clearer
and more understandable form.
[Joonas: Add Requires: tag]
Requires: 60a2066c5005 ("drm/i915/gem: Adjust vma offset for framebuffer mmap offset")
(cherry picked from commit 97b6784753da06d9d40232328efc5c5367e53417)Show less |
An unauthenticated remote attacker can use a malicious OPC UA client to send a crafted request to affected CODESYS products which can cause a DoS due to incorrect calculation of buffer size.
|
An Incorrect Calculation of Buffer Size vulnerability in Juniper Networks Junos OS SRX 5000 Series devices using SPC2 line cards while ALGs are enabled allows an attacker sending specific crafted packets to cause a trans...Show moreAn Incorrect Calculation of Buffer Size vulnerability in Juniper Networks Junos OS SRX 5000 Series devices using SPC2 line cards while ALGs are enabled allows an attacker sending specific crafted packets to cause a transit traffic Denial of Service (DoS).
Continued receipt and processing of these specific packets will sustain the Denial of Service condition.
This issue affects:
Juniper Networks Junos OS SRX 5000 Series with SPC2 with ALGs enabled.
* All versions earlier than 21.2R3-S7;
* 21.4 versions earlier than 21.4R3-S6;
* 22.1 versions earlier than 22.1R3-S5;
* 22.2 versions earlier than 22.2R3-S3;
* 22.3 versions earlier than 22.3R3-S2;
* 22.4 versions earlier than 22.4R3;
* 23.2 versions earlier than 23.2R2.Show less |
In the Linux kernel, the following vulnerability has been resolved:
l2tp: pass correct message length to ip6_append_data
l2tp_ip6_sendmsg needs to avoid accounting for the transport header
twice when splicing more data...Show moreIn the Linux kernel, the following vulnerability has been resolved:
l2tp: pass correct message length to ip6_append_data
l2tp_ip6_sendmsg needs to avoid accounting for the transport header
twice when splicing more data into an already partially-occupied skbuff.
To manage this, we check whether the skbuff contains data using
skb_queue_empty when deciding how much data to append using
ip6_append_data.
However, the code which performed the calculation was incorrect:
ulen = len + skb_queue_empty(&sk->sk_write_queue) ? transhdrlen : 0;
...due to C operator precedence, this ends up setting ulen to
transhdrlen for messages with a non-zero length, which results in
corrupted packets on the wire.
Add parentheses to correct the calculation in line with the original
intent.Show less |
In the Linux kernel, the following vulnerability has been resolved:
drm/i915/dsc: Fix the macro that calculates DSCC_/DSCA_ PPS reg address
Commit bd077259d0a9 ("drm/i915/vdsc: Add function to read any PPS
register") d...Show moreIn the Linux kernel, the following vulnerability has been resolved:
drm/i915/dsc: Fix the macro that calculates DSCC_/DSCA_ PPS reg address
Commit bd077259d0a9 ("drm/i915/vdsc: Add function to read any PPS
register") defines a new macro to calculate the DSC PPS register
addresses with PPS number as an input. This macro correctly calculates
the addresses till PPS 11 since the addresses increment by 4. So in that
case the following macro works correctly to give correct register
address:
_MMIO(_DSCA_PPS_0 + (pps) * 4)
However after PPS 11, the register address for PPS 12 increments by 12
because of RC Buffer memory allocation in between. Because of this
discontinuity in the address space, the macro calculates wrong addresses
for PPS 12 - 16 resulting into incorrect DSC PPS parameter value
read/writes causing DSC corruption.
This fixes it by correcting this macro to add the offset of 12 for PPS
>=12.
v3: Add correct paranthesis for pps argument (Jani Nikula)
(cherry picked from commit 6074be620c31dc2ae11af96a1a5ea95580976fb5)Show less |
In wipe_ns_memory of nsmemwipe.c, there is a possible incorrect size calculation due to a logic error in the code. This could lead to local information disclosure with no additional execution privileges needed. User inte...Show moreIn wipe_ns_memory of nsmemwipe.c, there is a possible incorrect size calculation due to a logic error in the code. This could lead to local information disclosure with no additional execution privileges needed. User interaction is not needed for exploitation.Show less |
In OpenBSD 7.4 before errata 002 and OpenBSD 7.3 before errata 019, a network buffer that had to be split at certain length that could crash the kernel after receiving specially crafted escape sequences. |
In OpenBSD 7.3 before errata 016, npppd(8) could crash by a l2tp message which has an AVP (Attribute-Value Pair) with wrong length.
|
A memory corruption vulnerability has been identified in PostScript interpreter in various Lexmark devices. The vulnerability can be leveraged by an attacker to execute arbitrary code.
|
In the Linux kernel, the following vulnerability has been resolved:
media: staging/intel-ipu3: Fix set_fmt error handling
If there in an error during a set_fmt, do not overwrite the previous
sizes with the invalid conf...Show moreIn the Linux kernel, the following vulnerability has been resolved:
media: staging/intel-ipu3: Fix set_fmt error handling
If there in an error during a set_fmt, do not overwrite the previous
sizes with the invalid config.
Without this patch, v4l2-compliance ends up allocating 4GiB of RAM and
causing the following OOPs
[ 38.662975] ipu3-imgu 0000:00:05.0: swiotlb buffer is full (sz: 4096 bytes)
[ 38.662980] DMA: Out of SW-IOMMU space for 4096 bytes at device 0000:00:05.0
[ 38.663010] general protection fault: 0000 [#1] PREEMPT SMPShow less |
An out-of-bounds write vulnerability exists in the sopen_FAMOS_read functionality of The Biosig Project libbiosig 2.5.0 and Master Branch (ab0ee111). A specially crafted .famos file can lead to arbitrary code execution....Show moreAn out-of-bounds write vulnerability exists in the sopen_FAMOS_read functionality of The Biosig Project libbiosig 2.5.0 and Master Branch (ab0ee111). A specially crafted .famos file can lead to arbitrary code execution. An attacker can provide a malicious file to trigger this vulnerability.Show less |
Undisclosed requests can cause the Traffic Management Microkernel (TMM) to terminate. For the Application Visibility and Reporting module, this may occur when the HTTP Analytics profile with URLs enabled under Collected...Show more
Undisclosed requests can cause the Traffic Management Microkernel (TMM) to terminate. For the Application Visibility and Reporting module, this may occur when the HTTP Analytics profile with URLs enabled under Collected Entities is configured on a virtual server and the DB variables avr.IncludeServerInURI or avr.CollectOnlyHostnameFromURI are enabled. For BIG-IP Advanced WAF and ASM, this may occur when either a DoS or Bot Defense profile is configured on a virtual server and the DB variables avr.IncludeServerInURI or avr.CollectOnlyHostnameFromURI are enabled.
Note: The DB variables avr.IncludeServerInURI and avr.CollectOnlyHostnameFromURI are not enabled by default. For more information about the HTTP Analytics profile and the Collect URLs setting, refer to K30875743: Create a new Analytics profile and attach it to your virtual servers https://my.f5.com/manage/s/article/K30875743 .
Note: Software versions which have reached End of Technical Support (EoTS) are not evaluatedShow less |
A potential buffer overflow exists in the Bluetooth LE HCI CPC sample application in the Gecko SDK which may result in a denial of service or remote code execution |
An integer overflow was found in the __vsyslog_internal function of the glibc library. This function is called by the syslog and vsyslog functions. This issue occurs when these functions are called with a very long messa...Show moreAn integer overflow was found in the __vsyslog_internal function of the glibc library. This function is called by the syslog and vsyslog functions. This issue occurs when these functions are called with a very long message, leading to an incorrect calculation of the buffer size to store the message, resulting in undefined behavior. This issue affects glibc 2.37 and newer.Show less |
A stack-based buffer overflow exists in IBM Merge Healthcare eFilm Workstation license server. A remote, unauthenticated attacker can exploit this vulnerability to achieve remote code execution with SYSTEM privileges.
|
A buffer overflow exists in IBM Merge Healthcare eFilm Workstation license server. A remote, unauthenticated attacker can exploit this vulnerability to achieve remote code execution. |
In versions of FreeBSD 12.4-RELEASE prior to 12.4-RELEASE-p7 and FreeBSD 13.2-RELEASE prior to 13.2-RELEASE-p5 the __sflush() stdio function in libc does not correctly update FILE objects' write space members for write-b...Show moreIn versions of FreeBSD 12.4-RELEASE prior to 12.4-RELEASE-p7 and FreeBSD 13.2-RELEASE prior to 13.2-RELEASE-p5 the __sflush() stdio function in libc does not correctly update FILE objects' write space members for write-buffered streams when the write(2) system call returns an error. Depending on the nature of an application that calls libc's stdio functions and the presence of errors returned from the write(2) system call (or an overridden stdio write routine) a heap buffer overflow may occur. Such overflows may lead to data corruption or the execution of arbitrary code at the privilege level of the calling program.Show less |
An issue was discovered in drivers/net/ethernet/intel/igb/igb_main.c in the IGB driver in the Linux kernel before 6.5.3. A buffer size may not be adequate for frames larger than the MTU. |
Unchecked user input length in /subsys/net/l2/wifi/wifi_shell.c can cause buffer overflows. |
In pda, there is a possible out of bounds read due to an incorrect calculation of buffer size. This could lead to local information disclosure with System execution privileges needed. User interaction is not needed for e...Show moreIn pda, there is a possible out of bounds read due to an incorrect calculation of buffer size. This could lead to local information disclosure with System execution privileges needed. User interaction is not needed for exploitation. Patch ID: ALPS07147572; Issue ID: ALPS07421076.Show less |